Detaching And Refitting The Primary Transfer Belt - Kyocera Mita FS-C5016N - Color LED Printer Service Manual

(2) Detaching and refitting the primary transfer belt

Procedure
1. Remove primary transfer unit (see previous
page).
2. Remove the two handles.
3. Remove the two screws and then make the
primary transfer unit two-fold.
4. Remove the primary transfer belt.
5. Check or replace the primary transfer belt
and then refit all the removed parts.
Primary transfer belt
Handle
Screw
Primary transfer unit
Figure 1-6-19
FS-C5016N
Screw
Handle
1-6-15