Detaching And Refitting The Paper Feed Roller - Kyocera Mita FS-C5016N - Color LED Printer Service Manual

FS-C5016N

(2) Detaching and refitting the paper feed roller

Procedure
1. Remove the paper feed unit (see previous
page).
2. Turn over the paper feed unit.
3. While pushing the lock release buttons and
then detach the joint.
4. Unlatch the latches and then remove paper
feed roller unit.
5. Unlatch the three latches and then remove
the feed bracket cover.
6. Remove the feed roller and pickup roller.
• The one-way clutch is built in to the pickup
gear Z32S. When the pickup gear Z32S is
installed again, the surface of one-way
clutch side is directed to feed bracket cover
side.
7. Check or replace the feed roller and then
refit all the removed parts.
1-6-6
Latches
Lock release
button
Joint
Lock release
button
Paper feed roller unit
Figure 1-6-8
Pickup gear Z32S
Pickup roller
Feed roller
Figure 1-6-9
One-way clutch
Latch
Latches
Feed bracket cover