General Error Handling; Maintenance Messages - Kyocera Mita FS-6750 Service Manual

6.3

General error handling

Maintenance messages

Table 6. 4
Message
Add paper
(paper source)
Missing waste
toner bottle
Replace waste
toner bottle
Clean printer
Press GO
Duplexer
rear cover open
Face-down tray
paper full
Load Cassette #
(paper size)/(paper type)*
*(paper size) and (paper type)
are displayed flashing alter-
nately.
Corrective action
The paper has run out. Supply paper according to the paper
source displayed (paper cassette, MP tray, or option paper
feeder). Messages indicating the printer status (Ready ,
Please wait Processing *, Waiting, and FormFeed
TimeOut *) are displayed alternately.
* These messages will not appear if the number of copies is
set to 2 or more.
The waste toner bottle is not installed. Replace the old waste
toner bottle with the new one which is included in the TK-
26/29E/CTK-45 toner kit.
The waste toner bottle has become full. The waste toner bot-
tle should be replaced when the message display eventually
shows Toner low TK-26. See Toner container replace-
ment, page 3-4.
Clean the inside of the printer, according to 3.3 Cleaning
the printer, page 3-5. This message will be displayed when
replacing the toner container after the message Replace
toner TK-26 has been displayed. After cleaning the inside
of the printer, press the GO key and the printer will be ready
for printing. If Auto Continue is set to On, printing will be
automatically resumed after a preset period of time.
Open the option duplexer rear cover, then close tightly.
The face-down output tray has become full (approximately
250 pages). Remove all printed pages from the face-down
output tray. When the printer senses that the face-down out-
put tray is empty again, it will continue printing into the
face-down output tray.
Paper whose size watches the size embedded in a print job is
empty. Set paper into the paper source as displayed on the
operator panel, and press the GO key to restart printing. The
paper source number (#) is only displayed when there is an
optional paper feeder installed. If you want to print from an
alternative paper source press the
Use alternative? and you can change to another paper
source. Further, you can change the paper source by pressing
the GO key.
After selecting a paper source and pressing the MENU key,
Paper Handling > appears. By pressing the > key, the
paper type setting menu appears. After setting the correct
paper type, press the ENTER key and printing starts.
6-6
Troubleshooting
General error handling
key or key to display
FS-6750