Table of Contents
Advertisement
3. Indicators and Messages
The tables on the following pages indicate how to respond to problems indicated by the operator panel indicators and messages.
3.1 Indicators
Indicator
Condition
Flashing
Lit
READY
Off
Flashing
DATA
Lit
Flashing
Lit
ATTENTION
Off
3.2 Maintenance Messages
The following table lists maintenance messages that you can deal with by yourself. If Call service person appears, turn off the
printer, disconnect the power cord, and contact your Kyocera Mita dealer.
Message
Add paper (paper
source)
Add staples
Call service
####:0123456
Call service
F###:
Call service
person
F0
Chad box full
Check chad box
Press GO
Clean printer
Press GO
Close finisher
cover
An error occurs that you can clear by yourself.
The printer is on-line. The printer is ready to print.
The printer is off-line. The printer stores but does not print received data. Also indicates when
printing is automatically stopped due to occurrence of an error.
Data transfer is taking place.
Either data is being processed, or data is being written onto the option memory card or hard disk.
The printer needs maintenance attention or the printer is warming up (Please wait).
A problem or an error occurs that you can clear by yourself. (For example, a paper jam occurs.)
Operations are normal.
The paper has run out. Supply paper according to the paper source displayed (paper cassette, MP
tray, or optional paper feeder).
Messages indicating the printer status (Ready, Please wait, Processing*, Waiting, and
FormFeed Time Out*) are displayed alternately.
* These messages will not appear when the number of copies is set to 2 or more.
No staples are installed in the stapler. Set it in the stapler.
#### represents a mechanical error (#=0, 1, 2, ...). Call a service.
The printer does not operate when this message is displayed.
The total number of pages printed is also indicated, e.g.
0123456.
F### represents a controller error (#=0, 1, 2, ...). Call a service.
The printer does not operate when this message is displayed.
This message means an error in data communications between the printer controller and the operator
panel. Call a service.
The printer does not operate when this message is displayed.
The punch unit chad box of the option document finisher is full. Discard the chads.
The punch unit waste box of the DF-70 document finisher is full or is not installed correctly. Check if the
box is properly installed, and then discard the chads if the box is full. Press the GO key to resume
printing.
Clean the inside of the printer. See
This message will be displayed when replacing the toner container after the message Replace
toner Clean printer is displayed. After cleaning the inside of the printer, press the GO key and
the printer will be ready for printing.
Close the option document finisher cover.
Description
Corrective Action
Toner Container Replacement on page
Chapter 4 Troubleshooting
6-1.
4-4
Advertisement
Chapters
Table of Contents
