Configuring Vrrp Parameters; Figure 79 Vrrp Configuration: Vrrp Parameters; Table 54 Vrrp Configuration: Vrrp Parameters - ZyXEL Communications ZyXEL Dimension ES-4024 User Manual

23.3.3 Configuring VRRP Parameters

After you set up an IP interface, configure the VRRP parameters in the VRRP Configuration
screen.

Figure 79 VRRP Configuration: VRRP Parameters

The following table describes the labels in this screen.

Table 54 VRRP Configuration: VRRP Parameters

LABEL
Active
Name
Network
Virtual Router ID
Advertisement Interval Specify the number of seconds between Hello message transmissions. The
Preempt Mode
Priority
Uplink Gateway
Primary Virtual IP
Secondary Virtual IP
Add
Cancel
Clear
Chapter 23 VRRP
DESCRIPTION
Select this option to enable this VRRP entry.
Enter a descriptive name for this VRRP entry.
Select an IP domain to which this VRRP entry applies.
Select a virtual router number (1 to 7) for which this VRRP entry is created.
You can configure up to seven virtual routers for one network.
default is 1.
Select this option to activate preempt mode.
Enter a number (between 1 and 254) to set the priority level. The bigger the
number, the higher the priority.
This field is 100 by default.
Enter the IP address of the uplink gateway in dotted decimal notation.
The ES-4024A checks the link to the uplink gateway.
Enter the IP address of the primary virtual router in dotted decimal notation.
This field is optional. Enter the IP address of a secondary virtual router in
dotted decimal notation. This field is ignored when you enter 0.0.0.0.
Click Add to apply the changes.
Click Cancel to discard all changes made in this table.
Click Clear to set the above fields back to the factory defaults.
ES-4024A User's Guide
151