Table of Contents
Advertisement
Table 134 IP Application > VRRP Status (continued)
LABEL
VR Status
Uplink
Status
Poll
Interval(s)
Stop
41.3 VRRP Configuration
The following sections describe the different parts of the VRRP Configuration
screen.
41.3.1 IP Interface Setup
Before configuring VRRP, first create an IP interface (or routing domain) in the IP
Setup screen (see the
Click IP Application, VRRP and click the Configuration link to display the
VRRP Configuration screen as shown next.
Note: You can only configure VRRP on interfaces with unique VLAN IDs.
XGS4700-48F User's Guide
DESCRIPTION
This field displays the status of the virtual router.
This field is Master indicating that this Switch functions as the master
router.
This field is Backup indicating that this Switch functions as a backup
router.
This field displays Init when this Switch is initiating the VRRP protocol or
when the Uplink Status field displays Dead.
This field displays the status of the link between this Switch and the uplink
gateway.
This field is Alive indicating that the link between this Switch and the
uplink gateway is up. Otherwise, this field is Dead.
This field displays Probe when this Switch is check for the link state.
The text box displays how often (in seconds) this screen refreshes. You
may change the refresh interval by typing a new number in the text box
and then clicking Set Interval.
Click Stop to halt system statistic polling.
Section 8.6 on page 113
Chapter 41 VRRP
for more information).
371
Advertisement
Table of Contents
Troubleshooting
