Connecting To A Server - Bay Networks FastLink II User Manual

Removing a Connection
To remove a connection from the list:
1
2

Connecting to a Server

Before you connect, be sure that:
Š
Š
Š
Refer to either of the chapters "Connecting From DOS" or "Connecting From Windows" below for complete
information on how to set up your system in general prior to connecting.
To make the connection:
1
2
3
Once the connection is established, a message box appears showing that the operation was successful, and also
details features of the connection.
Highlight the Connection drop-down box, and select the connection you'd like to remove.
Press [Remove] to remove the connection from the list.
You have set the connection settings correctly for dialing the Remote Annex server.
You have set the correct configuration and preferences in the Setup dialog.
You have loaded all the required drivers, such as LSL.COM and FLODI.COM.
Be sure the Connection Status line at the bottom of the screen indicates "Idle." If not, Press
[Disconnect] to cancel any previous connection or connection-in-progress.
Highlight the Connection drop-down box, and select the appropriate connection.
Press [Connect].
FastLink II activates the modem and dials the server. Once the phone link is created between the two
modems, FastLink II and the server exchange the information necessary to establish the connection.
If all goes well, after a few seconds the connection is established.
The Connection Status line at the bottom of the screen lets you monitor the progress of the
connection.
37