Chapter 12
Configuring Interfaces
Configuring the Beacon Mode
By default, the beacon mode is disabled on all switches. The beacon mode is indicated by a flashing
green light that helps you identify the physical location of the specified interface.
Identifying the Beacon LEDs
Figure 12-2
Figure 12-2
1
2
Each port has one link LED on the left and one speed LED on the right.
The speed LED displays the speed of the port interface:
•
•
•
OL-7753-01
displays the status, link, and speed LEDs in a 16-port switching module.
Cisco MDS 9000 Family Switch Interface Modes
1
3
Status LED
1/2-Gbps Fibre Channel port group
Off—The interface attached to that port is functioning at 1000 Mbps.
On (solid green)—The interface attached to that port is functioning at 2000 Mbps (for 2 Gbps
interfaces).
On (flashing green)—The interface is in loopback mode.
2
3
Link LEDs and speed LEDs
4
Asset tag (refer to the Cisco MDS 9000
Family Hardware Installation Guide).
Cisco MDS 9000 Fabric Manager Switch Configuration Guide
Configuring Fibre Channel Interfaces
4
12-9