Chapter 9 Managing Module; Identifying Module Leds - Cisco DS-C9216I-K9 Configuration Manual

Chapter 9 Managing Modules

Identifying Module LEDs

Table 9-3
MDS 9000 Family switches.
Table 9-3
Module
Fixed switching module
Optional switching
module
Table 9-4
synchronized to the active supervisor module.
OL-7753-01
describe the LED location, type, and status for supervisor and switching modules used in Cisco
Module LEDs on a Cisco MDS 9200 Series Switch
LED Type
Status
System
lists the system and power management LEDs on a redundant supervisor module that are
Status Description
Green All chassis environmental monitors (power
•
supply, fan, temperature sensor, clock, and
chassis) are reporting OK.
Sufficient power is available for all
•
modules
Orange Any one of the chassis environmental
•
monitors (power supply, fan, temperature
sensor, clock, and chassis) failed.
Sufficient power is not available for all
•
modules.
Incompatible power supplies are installed.
•
The redundant clock failed.
•
Red The diagnostic test failed.
•
The module is not operational because a
•
fault occurred during the initialization
sequence.
A temperature condition occurred. (A
•
major threshold was exceeded during
environmental monitoring.)
Green All diagnostics pass. The module is operational
(normal initialization sequence).
Orange The module is booting or running
•
diagnostics (normal initialization
sequence).
An over temperature condition occurred.
•
(A minor threshold was exceeded during
environmental monitoring.)
Red The diagnostic test failed. The module is
•
not operational because a fault occurred
during the initialization sequence.
An over temperature condition occurred.
•
(A major threshold was exceeded during
environmental monitoring.)
Cisco MDS 9000 Fabric Manager Switch Configuration Guide

Identifying Module LEDs

9-3