Creating Fcip Profiles; Creating Fcip Links - Cisco DS-C9216I-K9 Configuration Manual

Configuring FCIP
Configure the peer IP address for the FCIP interface.
Step 4
Enable the interface.
Step 5

Creating FCIP Profiles

To create a FCIP profile, you must assign a local IP address of a Gigabit Ethernet interface or
subinterface to the FCIP profile.
Figure 24-8
IP address of Gigabit Ethernet
interface 3/1 = 10.100.1.25

Creating FCIP Links

When two FCIP link end points are created, a FCIP link is established between the two IPS modules. To
create a FCIP link, assign a profile to the FCIP interface and configure the peer information. The peer
IP switch information initiates (creates) a FCIP link to that peer switch.
Figure 24-9
Connecting switch (peer) = 10.1.1.1
IP address of Gigabit Ethernet
interface 3/1 = 10.100.1.25
Cisco MDS 9000 Fabric Manager Switch Configuration Guide
24-10
Assigning Profiles to Each Gigabit Ethernet Interface
Switch 1
IP router
Assigning Profiles to Each Gigabit Ethernet Interface
Endpoint
Interface FCIP = 51
Profile = 10
Switch 1
FCIP link
Switch 1
IP router
IP router
IP
Network
IP address of Gigabit Ethernet
Endpoint
Interface FCIP = 52
Profile = 20
Connecting switch (peer) = 10.100.1.25
Virtual (E) ISL
IP router
IP
network
IP address of Gigabit Ethernet
Chapter 24 Configuring IP Storage
Switch 2
interface 3/1 = 10.1.1.1
Switch 2
Switch 2
interface 3/1 = 10.1.1.1
OL-7753-01