Call Home Configuration Overview - Cisco DS-C9216I-K9 Configuration Manual

Chapter 25 Configuring Call Home
Table 25-6
Data Item (Plain text and XML)
Affected FRU name
Affected FRU serial number
Affected FRU part number
FRU slot
FRU hardware version
FRU software version
Command output name
Attachment type
MIME type
Command output text

Call Home Configuration Overview

When configuring Call Home, keep the following points in mind:
•
•
•
•
To configure Call Home, use the different tabs on the Call Home dialog box, as summarized below:
Assign contact information and enable the Call Home feature using the General tab (see the
Step 1
"Configuring Call Home Attributes" section on page
default, and you must enter an e-mail address that identifies the source of Call Home notifications.
Configure the destination e-mail addresses for Call Home notifications using the Destinations tab (see
Step 2
the
more e-mail addresses that will receive Call Home notifications.
OL-7753-01
Plain Text and XML Messages (continued)
You must configure at least one E-mail server and at least one destination profile. The destination
profile(s) used depends on whether the notification is sent to a pager, e-mail, or automated service
such as Cisco AutoNotify.
You must configure the contact name (SNMP server contact), phone, and street address information
before enabling Call Home.
The Cisco MDS 9000 switch must have IP connectivity to an E-mail server.
To use Cisco AutoNotify you must obtain an active service contract for the device.
"Configuring Call Home Destination Attributes" section on page
Description (Plain text and XML) XML Tag (XML only)
Name of the affected FRU
generating the event message.
Serial number of affected FRU.
Part number of affected FRU.
Slot number of FRU generating
the event message.
Hardware version of affected
FRU.
Software version(s) running on
affected FRU.
Exact command that was run.
For example, show
running-config command.
Specifically command output.
Normally text or plain or
encoding type.
Output of command
automatically executed.
25-12). The Call Home feature is not enabled by
Cisco MDS 9000 Fabric Manager Switch Configuration Guide
Call Home Configuration Overview
/mml/body/fru/name
/mml/body/fru/serialNo
/mml/body/fru/partNo
/mml/body/fru/slot
/mml/body/fru/hwVersion
/mml/body/fru/swVersion
/mml/attachments/attachment/na
me
/mml/attachments/attachment/ty
pe
/mml/attachments/attachment/m
ime
/mml/attachments/attachment/at
data
25-12). You can identify one more
25-11