Viewing Link State Records; Viewing Fspf Links; Configuring Fspf For A Specific Interface - Cisco DS-C9216I-K9 Configuration Manual

Chapter 21 Configuring Fibre Channel Routing Services and Protocols
Table 21-3
LSR Option
Acknowledgement interval
(RxmtInterval)
Refresh time (LSRefreshTime)
Maximum age (MaxAge)

Viewing Link State Records

To monitor FSPF LSRs from the Device Manager, choose FC > FSPF and click the LSDB LSRs tab.

Viewing FSPF Links

To view FSPF links from the Device Manager, choose FC > FSPF and click the LSDB Links tab.

Configuring FSPF for a Specific Interface

Several FSPF commands are available on a per interface basis. The following configuration procedures
apply to an interface in a specific VSAN and are described in this section.
This section contains the following topics:
•
•
•
•
•
•
•
OL-7753-01
LSR Default Settings
Configuring FSPF Interfaces, page 21-6
Computing Route Cost, page 21-6
Specifying Hello Time Intervals, page 21-6
Specifying Dead Intervals, page 21-6
Disabling FSPF for Specific Interfaces, page 21-6
Retransmitting Intervals, page 21-6
Viewing FSPF Interface Statistics, page 21-7
Default
5 seconds
30 minutes
60 minutes
Cisco MDS 9000 Fabric Manager Switch Configuration Guide
Configuring FSPF for a Specific Interface
Description
The time a switch waits for an
acknowledgement from the LSR
before retransmission.
The time a switch waits before
sending an LSR refresh
transmission.
The time a switch waits before
dropping the LSR from the
database.
21-5