Verifying Interfaces; Verifying Extended Link Protocols (Elp); Checking Trunk Status - Cisco DS-C9216I-K9 Configuration Manual

Configuring FCIP
Click the Tunnels tab if it is not already selected. The FCIP Tunnels dialog box lists the remote IP
Step 4
address of the interface together with optional attributes.
Click the Create button. You see the Create FCIP Tunnels dialog box.
Step 5
Enter the entity ID in the ID field.
Step 6
Enter a remote IP address as the endpoint to which you want to link.
Step 7
Enter all the optional information, if desired.
Step 8
Click Create to add this tunnel to the table. Click Close to close the Create FCIP Tunnels dialog box
Step 9
without adding the tunnel.

Verifying Interfaces

To verify the interfaces, follow these steps:
Be sure you are connected to a switch that contains an IPS module.
Step 1
Open Device Manager.
Step 2
Choose Interface > FCIP.
Step 3
Click the Interfaces tab (if it is not already selected) to see the FCIP Interfaces dialog box.
Step 4

Verifying Extended Link Protocols (ELP)

To verify the extended link protocol, follow these steps:
Be sure you are connected to a switch that contains an IPS module.
Step 1
Open Device Manager.
Step 2
Step 3 Choose IP > FCIP.
Step 4 Click the ELP tab (if it is not already selected) to see the FCIP ELP dialogist.

Checking Trunk Status

To check the trunk status, follow these steps:
Step 1 Be sure you are connected to a switch that contains an IPS module.
Step 2 Open Device Manager.
Choose IP > FCIP.
Step 3
Click the Trunk Status tab (if it is not already selected) to see the FCIP Trunk Status dialog box.
Step 4
Cisco MDS 9000 Fabric Manager Switch Configuration Guide
24-12
Chapter 24 Configuring IP Storage
OL-7753-01