Novell NETWARE 6-DOCUMENTATION Manual page 1793

Accepting and Advertising Services from a Network Not Listed in the
Routing Information Table
82
Internetwork Packet Exchange
Pace Override —Specifies the maximum number of SAP packets
that can be sent each second through this interface. The default—and
maximum—pace for SAP packets is 9 pps.
The default value for this parameter is 0, which means do not
override the current pace.
Packet Size Override —Specifies the size, in bytes, of SAP packets
sent on this interface. The default value is 0, which means do not
override.
Each router on the network segment must use the same SAP packet
size.
6
Press Esc and save your changes.
7
Press Esc to return to the Internetworking Configuration menu.
8
If you want these changes to take effect immediately, select Reinitialize
System .
If you want to configure other parameters, do so now, then reinitialize the
system when you are finished.
Novell Internet Access Server 4.1 routing software includes a SET command
that enables an IPX router to accept and advertise a service from another
network, even if the network number associated with the service is not listed
in the router's Routing Information Table.
The syntax of this command is as follows:
SET REQUIRED NETWORK FOR SERVICES=ON|OFF
To understand how this command works, consider
which shows two directly connected IPX routers, one serving a large
backbone network, the other serving a NetWare LAN.
Figure 12 on page 83,