Novell NETWARE 6-DOCUMENTATION Manual page 1565

If you are running multiple FTP servers on your cluster, repeat the ADD and
DEL SECONDARY IPADDRESS lines for each FTP server, because each
FTP server requires its own IP address. Also, each FTP server must have its
own uniquely named configuration file which specifies the FTP server's IP
address and shared volume directory. Running FTP Server in ACTIVE/
ACTIVE mode is required if you plan to run more than one FTP Server on the
same NetWare server.
For example, if you have three FTP servers on your cluster, you can create
three configuration files named FTPSERV1.CFG, FTPSERV2.CFG, and
FTPSERV3.CFG and then copy them to the SYS:\ETC directory of each
NetWare server in the cluster that will run the FTP servers. Each configuration
file contains the IP address and shared volume directory for its corresponding
FTP server. In this example, you would add the following lines to the
AUTOEXEC.NCF file of each server in the cluster that will run the three FTP
servers in ACTIVE/ACTIVE mode:
ADD SECONDARY IPADDRESS A.B.C.D NOARP
ADD SECONDARY IPADDRESS A.B.C.D NOARP
ADD SECONDARY IPADDRESS A.B.C.D NOARP
NWFTPD -C FTPSERV1.CFG
NWFTPD -C FTPSERV2.CFG
NWFTPD -C FTPSERV3.CFG
LOAD DELAY.NLM
DELAY 5
DEL SECONDARY IPADDRESS A.B.C.D
DEL SECONDARY IPADDRESS A.B.C.D
DEL SECONDARY IPADDRESS A.B.C.D
DELAY.NLM provides enough time for the FTP server to load before the
secondary IP addresses are deleted. The delay time might need to be altered to
ensure enough time is allotted.
IMPORTANT:
If you are also running Netscape* Enterprise Server in ACTIVE/
ACTIVE mode on the same server, be sure to add the lines in the above example
before the NSWEB command.
47
Configuring with Cluster Services