Novell NETWARE 6-DOCUMENTATION Manual page 1928

AppleTalk Outgoing Routing Information Filter Example
68
Filter Configuration
5
Press Esc and save the filter information.
6
Select Exceptions .
This lists the exceptions to the filter list. Depending on the Action
parameter setting, routes that match a filter on this list are always or are
never permitted or denied, even if another filter is configured to do the
opposite.
7
Modify the exceptions list.
Select a filter from the list and press Enter to modify the filter or Del to
remove it. Press Ins to add a new filter. Refer to Step 4 and Step 5 to
modify or add a filter.
8
Select Status and toggle the choice to read Enabled or Disabled .
Any configured filters immediately become active (enabled) or inactive
(disabled).
9
Press Esc to save the information and return to the Configure AppleTalk
Filters menu.
In the following example, the Accounting department is connected to the
FDDI backbone by Router C. One of the AppleTalk networks within
Accounting is 165-170. Because access to this network from outside the
Accounting department is not required, the administrator has chosen not to
propagate a route to this network outside the Accounting department.
8 on page 69 shows the internetwork topology.
NOTE:
When you configure a filter for a primary WAN call, an equivalent filter is
automatically generated for the backup call. If the primary call should fail, the
backup call is automatically connected.
Figure