Novell NETWARE 6-DOCUMENTATION Manual page 1917

select a LAN interface, a WAN interface, or all interfaces. The
default is All Interfaces .
If you specified Interface Group as the Destination Interface Type ,
select the specific interface group on which you want to filter the
service.
Destination Circuit —If you selected a WAN interface destination,
press Enter to define optional circuit information:
Local Frame Relay DLCI # (for frame relay)—The DLCI circuit
number used for calls.
Remote System ID (for PPP, X.25, or ATM)—The name of the
remote system server or remote peer associated with this circuit.
Circuit Parameter Type (for X.25 or ATM)—The type of virtual
circuit used to establish a connection.
Remote DTE Address (for X.25)—The X.121 DTE address assigned
to the specific remote DTE.
Remote ATM Address (for ATM)—The address assigned to the
specific remote ATM.
Packet Type —Press Enter and select a packet type from the list.
The Protocol and Port(s) fields are automatically filled in, according
to your packet type selection.
Source Address Type —Press Enter and select Any Address , Host
, or Network .
Source TCP/IP Address —Enter the address and subnet mask of the
network or host.
Destination Address Type —Press Enter and select Any Address ,
Host , or Network .
Destination TCP/IP Address —Enter the address and subnet mask of
the network or host.
Comment —Enter an optional short description.
Logging —Optionally select Enabled to log packets that match the
Filters or Exceptions definitions.
The header of packets that match the Filters or Exceptions
definitions are logged as long as the global logging status and this
57
Setting Up