Novell NETWARE 6-DOCUMENTATION Manual page 1911

Source (or Destination ) Circuit —If you selected a WAN source (or
destination), press Enter to define optional circuit information:
Local Frame Relay DLCI # (for frame relay)—The DLCI circuit
number used for calls.
Remote System ID (for PPP, X.25, or ATM)—The name of the
remote system server or remote peer associated with this circuit.
Circuit Parameter Type (for X.25 or ATM)—The type of virtual
circuit used to establish a connection.
Remote DTE Address (for X.25)—The X.121 DTE address assigned
to the specific remote DTE.
Remote ATM Address (for ATM)—The address assigned to the
specific remote ATM.
Metric Value —Enter a number to be associated with the route.
This option is enabled only if the filter is configured to permit or
advertise the route. If you leave this option blank, the TCP/IP routing
table is consulted automatically for the required information.
Comment —Enter an optional short description.
Logging —Optionally select Enabled to log packets that match the
Filters or Exceptions definitions.
The header of packets that match the Filters or Exceptions
definitions are logged as long as the global logging status and this
logging status are both enabled. The logs are viewed using the
NetWare Administrator utility.
6
Press Esc and save the filter information.
7
Select Exceptions .
Lists the exceptions to the configured filters. Depending on the Action
parameter setting, packets that match a filter on this list are always or are
never advertised (or hidden), even if another filter is configured to do the
opposite.
8
Modify the exceptions list.
Select a filter from the list and press Enter to modify the filter or Del to
remove it. Press Ins to add a new filter. Refer to Step 5 and Step 6 if you
are adding or modifying a filter.
9
Press Esc to save the information and return to the Configure TCP/IP
Filters menu.
51
Setting Up