Novell NETWARE 6-DOCUMENTATION Manual page 1766

Configuring Static Services
Ticks to Network —Number of ticks used to allow a packet to reach
the destination network. Add one tick to this value for each LAN
hop.
5
Press Esc and save your changes.
6
Press Esc to return to the Internetworking Configuration menu.
7
If you want these changes to take effect immediately, select Reinitialize
System .
If you want to configure other parameters, do so now, then reinitialize the
system when you are finished.
HINT:
If you plan to configure any uncommon services, we recommend using
STATICON to avoid errors.
To configure static services with NIASCFG, complete the following steps:
1
Load NIASCFG, then select the following parameter path:
Select Configure NIAS > Protocols and Routing > Bindings > a WAN
interface > WAN Call Destinations.
2
Select a WAN call destination from the list, or press Ins to choose from
a list of available call destinations.
3
Select Static Services .
A new screen displays any configured static services.
4
Press Ins, then enter the following information:
Service Name —Name of the service to be accessed through the on-
demand call. This name, which is typically the server name, is added
to the local service and routing tables.
NOTE:
If you need to obtain service name information, use the IPXCON
utility at the remote router. If you use STATICON to configure static services,
this information is obtained automatically.
Service Type —SAP service type for this service, expressed as a
hexadecimal number. This is typically the file server type (0004).
Press Ins to display a list of service types.
Service Address Network —IPX network number of the service. If
you are specifying a file service or a service on a server or router,
enter the internal network number of that server or router.
55
Setting Up