Novell NETWARE 6-DOCUMENTATION Manual page 1916

56
Filter Configuration
5
Modify the packet list.
Select a filter from the list and press Enter to modify the filter or Del to
remove it. Press Ins to add a new packet filter.
If you are modifying an existing filter or adding a new filter, specify the
following parameters from the Define Filter menu:
NOTE:
You cannot modify a predefined packet type.
Source Interface Type —Press Enter and select Interface or
Interface Group as the source type.
Source Interface —Press Enter and select an interface or interface
group from the list.
If you specified Interface as the Source Interface Type , select a
specific interface on which you want to filter the service. You can
select a LAN interface, a WAN interface, or all interfaces. The
default is All Interfaces .
If you specified Interface Group as the Source Interface Type , select
the specific interface group on which you want to filter the service.
Source Circuit —If you selected a WAN interface source, press Enter
to define optional circuit information:
Local Frame Relay DLCI # (for frame relay)—The DLCI circuit
number used for calls.
Remote System ID (for PPP, X.25, or ATM)—The name of the
remote system server or remote peer associated with this circuit.
Circuit Parameter Type (for X.25 or ATM)—The type of virtual
circuit used to establish a connection.
Remote DTE Address (for X.25)—The X.121 DTE address assigned
to the specific remote DTE.
Remote ATM Address (for ATM)—The address assigned to the
specific remote ATM.
Destination Interface Type —Select Interface or Interface Group as
the interface type.
Destination Interface —Press Enter and select an interface or
interface group from the list.
If you specified Interface as the Destination Interface Type , select a
specific interface on which you want to filter the service. You can