Novell NETWARE 6-DOCUMENTATION Manual page 1892

32
Filter Configuration
can select a LAN interface, a WAN interface, the internal network,
or all interfaces. The default is All Interfaces .
Source (or Destination ) Circuit —If you selected a WAN source (or
destination), press Enter to define optional circuit information:
Local Frame Relay DLCI # (for frame relay)—The DLCI circuit
number used for calls.
Remote System ID (for PPP, X.25, or ATM)—The name of the
remote system server or remote peer associated with this circuit.
Circuit Parameter Type (for X.25 or ATM)—The type of virtual
circuit used to establish a connection.
Remote DTE Address (for X.25)—The X.121 DTE address assigned
to the specific remote DTE.
Remote ATM Address (for ATM)—The address assigned to the
specific remote ATM.
NOTE:
If the optional fields are left blank, the filter will match all WAN calls
on the interface. If authentication is not enabled and the optional fields are
specified, the filter will not work.
Comment —Enter an optional short description.
6
Press Esc and save the information.
7
Select Exceptions .
This displays a list of exceptions to the incoming (or outgoing) SAP
filters. Depending on the Action parameter setting, services that match a
filter on this list are always or are never accepted (or advertised) by the
router, even if another filter is configured to do the opposite.
8
Modify the exceptions list.
Select a service from the list and press Enter to modify the service or Del
to remove it. Press Ins to add a new service. Refer to Step 5 and Step 6
to modify or add an exception.
9
Press Esc to save the information and return to the Configure IPX Filters
menu.