Novell NETWARE 6-DOCUMENTATION Manual page 1924

64
Filter Configuration
11-20, 21-30, specifying an extended range of 1-30 will filter all
devices in the 1-9, 10, 11-20, and 21-30 extended networks.
Zone —Press Enter , then type the name of the AppleTalk zone in
which the filtered device is located.
User Circuit —If you selected a WAN interface, press Enter to
modify the following optional circuit information:
Local Frame Relay DLCI # (for frame relay)—The DLCI circuit
number used for calls.
Remote System ID (for PPP, X.25, ISDN, or ATM)—The name of
the remote system server or remote peer associated with this circuit.
Circuit Parameter Type (for X.25 or ATM)—The type of virtual
circuit used to establish a connection.
Remote DTE Address (for X.25)—The X.121 DTE address assigned
to the specific remote DTE.
Remote ATM Address (for ATM)—The address assigned to the
specific remote ATM.
Comment —Enter an optional short description.
5
Press Esc and save the filter information.
6
Select Exceptions .
This lists the exceptions to the device filter list. Depending on the Action
parameter setting, devices that match a filter on this list are always or are
never permitted or denied, even if another filter is configured to do the
opposite.
7
Modify the exceptions list.
Select a filter from the list and press Enter to modify the filter or Del to
remove it. Press Ins to add a new filter. Refer to Step 4 and Step 5 to
modify or add a filter to the exceptions list.
8
Select Status and toggle the choice to read Enabled or Disabled .
All configured filters immediately become active (enabled) or inactive
(disabled).
9
Press Esc to save the information and return to the Configure AppleTalk
Filters menu.