Novell NETWARE 6-DOCUMENTATION Manual page 1889

How to Save Filters to a Text File
Configuring IPX Filters
taken on the Exceptions list is always the opposite of the action taken
on the Filters list.
You select a filter from the list and press Enter to modify the filter
or Del to remove it. Press Ins to add a new filter. For example, you
could use a filter to hide all Marketing file servers from Engineering,
except the server named MKTG-DEMO.
6
Press Esc to exit.
NOTE:
All filters affecting a primary call are automatically mapped to a configured
backup call. Optionally, the automatic mapping of filtering can be disabled with the
LOAD FILTSRV NOBACKUP command. With automatic mapping of filtering
disabled, you can configure a selective filtering scheme that is specific to the
needs of a backup link. The primary call and its associated backup call should use
the same remote system ID. For information on configuring backup calls, refer to
"Configuring Backup Calls."
To save your filter information to a text file, complete the following steps:
1
Load FILTCFG.
The Filter Configuration Available Options menu is displayed.
2
Select Save Filters to a Text File, then press Enter.
3
Enter the pathname for the filter file.
For example, enter SYS:\ETC\TEMP . You can also save the filter file
to a floppy disk (for example, A:\filename).
The Internetwork Packet Exchange
following types of filters:
SAP (service information) filters
Outgoing SAP filters (services advertised)
Incoming SAP filters (services accepted)
RIP (routing information) filters
Outgoing RIP filters (routes advertised)
Incoming RIP filters (routes accepted)
NetBIOS and packet forwarding filters
(IPX ) protocol supports the
TM TM
29
Setting Up