Novell NETWARE 6-DOCUMENTATION Manual page 1901

Destination Interface —Press Enter and select a destination from the
list of network interfaces or interface groups.
If you specified Interface as the Source (or Destination ) Interface
Type , select a specific interface on which you want to filter the
service. You can select a LAN interface, a WAN interface, the
internal network, or all interfaces. The default is All Interfaces .
If you specified Interface Group as the Destination (or Source )
Interface Type , select the specific interface group on which you
want to filter the service.
Destination Circuit—If the destination is a WAN interface, press
Enter to modify the following optional circuit information:
Local Frame Relay DLCI # (for frame relay)—The DLCI circuit
number used for calls.
Remote System ID (for PPP, X.25, or ATM)—The name of the
remote system server or remote peer associated with this circuit.
Circuit Parameter Type (for X.25 or ATM)—The type of virtual
circuit used to establish a connection.
Remote DTE Address (for X.25)—The X.121 DTE address assigned
to the specific remote DTE.
Remote ATM Address (for ATM)—The address assigned to the
specific remote ATM.
Packet Description —Press Enter and select from a list of defined
IPX packet types, or press Ins to define a packet type.
Enter the following information to define the type of IPX packet you
can filter:
Name —Enter a name for the packet.
Packet Type —Enter a 1-byte packet type number in hexadecimal.
The FF wildcard matches all packet numbers.
Destination Socket —Enter a 2-byte socket number in hexadecimal.
The wildcard FFFF matches all socket numbers.
Comment —Enter an optional short description.
Source Address Type —Press Enter and select Any Address ,
Network , or Node as the source address type.
41
Setting Up