Novell NETWARE 6-DOCUMENTATION Manual page 2251

Installing and Starting ConsoleOne
Windows
18
ConsoleOne User Guide
If you install this release of ConsoleOne on the SYS volume of a NetWare
server, it overwrites ConsoleOne 1.2x and disables ConsoleOne 1.1.
However, existing ConsoleOne 1.2 snap-ins are retained.
If you install this release of ConsoleOne locally on a workstation hard
disk, other products such as eDirectory might not be able to find the right
place to add snap-ins to the installation. In such a case, it is up to you to
move any snap-ins from other products into the new installation.
ConsoleOne is typically installed as part of a larger product, such as Novell
eDirectory or NetWare. If this release of ConsoleOne hasn't been installed by
a larger product, you can install it using the procedure below for your
platform.
In This Section
"Windows" on page 18
"NetWare" on page 21
"Linux" on page 23
"Solaris" on page 25
"Tru64 UNIX" on page 27
You can install and run ConsoleOne locally on a Windows workstation or
server, or you can install it remotely on a NetWare or Windows server and run
it through a mapped or shared drive pointing to that server. If you install
locally on a workstation, other Novell products such as Novell eDirectory
might not be able to add needed snap-ins to your installation. For this reason,
we recommend a server installation.