Novell NETWARE 6-DOCUMENTATION Manual page 1926

Table 7
How to Configure AppleTalk Route Filtering
66
Filter Configuration
Parameters for AppleTalk Device Hiding Filter Example
Parameter
Action
Device Name
Device Type
Device Location Type
Device Location
User Location Type
User Location
User Circuit
Before you begin, make sure that filtering support is enabled for AppleTalk in
NIASCFG. Otherwise, filtering will not work.
To configure AppleTalk routing information filtering for incoming (or
outgoing) route filters, complete the following steps:
1
Load FILTCFG, then select the following parameter path:
Select Configure AppleTalk Filters > Incoming Route Filters (or
Outgoing Route Filters )
2
Select Action and toggle the choice to permit or deny the routes listed in
the filter list.
This specifies the action taken with a route that appears in the filter list.
If you select to permit routes, the AppleTalk router accepts (or advertises)
only the routes from (or to) the networks in the filter list. If you select to
deny routes, the AppleTalk router does not accept (or advertise) specific
routes from (or to) specific networks in the filter list, but does accept (or
advertise) all other entries in the routing table.
3
Select Filters .
This lists the filters that are permitted or denied, according to the Action
parameter setting.
Value
Deny
= (for all NBP names)
LaserWriter
Zone
Accounting
Interface
FDDI Backbone-Interface connecting to FDDI
All Circuits