Novell NETWARE 6-DOCUMENTATION Manual page 1920

Table 6
Configuring AppleTalk Filters
60
Filter Configuration
predefined services list. The allowable destinations are limited to the
corporate mail servers. Host 153.5.3.1 is the only mail server defined.
When configuring this example, set the parameters as shown in
Parameters for IP Packet Forwarding Filter Example
Parameter
Action
Filters List
Filter 1:
Source Interface Type
Source Interface
Destination Interface Type
Destination Interface
Packet Type
Source Address Type
Destination Address Type
Filters List
Filter 2:
Source Interface Type
Source Interface
Destination Interface Type
Destination Interface
Packet Type
Source Address Type
Destination Address Type
Destination TCP/IP Address
AppleTalk supports the following types of filters:
Device hiding filters
Outgoing route filters (routes advertised)
Incoming route filters (routes accepted)
NOTE:
When you configure a filter for a primary WAN call, an equivalent filter is
automatically generated for the backup call. If the primary call should fail, the
backup call is automatically connected. You can only view primary filters using
FILTCFG. Backup filters do not appear in FILTCFG.
Value
Permit Packets
.
.
Interface
FDDI backbone
Interface
All Interfaces
Any
Any Address
Any Address
.
.
Interface
NE2000_B
Interface
All Interfaces
SMTP
Any Address
Host
153.5.3.1
Table 6 .