Novell NETWARE 6-DOCUMENTATION Manual page 1908

Subnetwork Mask —Enter a 4-byte mask address in dotted decimal
or hexadecimal notation. Do this only if you selected Network for
the Route to Network/Hosts parameter.
Source (or Destination ) Type —Select Interface , Interface Group ,
or Network as the source (or destination) type.
Source (or Destination )—Press Enter , then select the source (or
destination) that the route is advertised to or blocked from.
If you specified Interface for the Source (or Destination ) Type
parameter, select a specific interface on which you want to filter the
service. You can select a LAN interface, a WAN interface, or all
interfaces. The default is All Interfaces .
If you specified Interface Group for the Source (or Destination )
Type parameter, select the specific interface group on which you
want to filter the service.
If you selected Network for the Source (or Destination ) Type
parameter, type the TCP/IP address and the subnet mask.
Source (or Destination ) Circuit —If you selected a WAN source (or
destination), press Enter to define optional circuit information:
Local Frame Relay DLCI # (for frame relay)—The DLCI circuit
number used for calls.
Remote System ID (for PPP, X.25, or ATM)—The name of the
remote system server or remote peer associated with this circuit.
Circuit Parameter Type (for X.25 or ATM)—The type of virtual
circuit used to establish a connection.
Remote DTE Address (for X.25)—The X.121 DTE address assigned
to the specific remote DTE.
Remote ATM Address (for ATM)—The address assigned to the
specific remote ATM.
Advertised Hop Count —Enter a number from 1 to 16.
This option is enabled if the filter is configured to permit or advertise
the route. If you leave this option blank, the TCP/IP routing table is
consulted automatically for the required information. A value of 16
disables the route.
Comment —Enter an optional short description.
48
Filter Configuration