Novell NETWARE 6-DOCUMENTATION Manual page 1906

Configuring TCP/IP Filters
46
Filter Configuration
Parameter
Source Interface Type
Source Interface
Source Circuit
Destination Interface Type
Destination Interface
Destination Circuit
Packet
Source Address Type
Source IPX Address
Destination Address
Destination IPX Address
TCP/IP supports the following filters:
Incoming RIP filters (routing information)
Outgoing RIP filters (routing advertisement)
Packet forwarding filters
Incoming Exterior Gateway Protocol (EGP) filters (routing information)
Outgoing EGP filters (routing advertisement)
Open Shortest Path First (OSPF) external route filters
Refer to Understanding
NOTE:
When you configure a filter for a primary WAN call, an equivalent filter is
automatically generated for the backup call. If the primary call should fail, the
backup call is automatically connected.
This section contains the following topics:
"How to Configure IP Routing Information Filters" on page 47
"How to Configure EGP Filters" on page 49
"How to Configure OSPF External Route Filters" on page 52
"IP Routing Information Filter Example" on page 53
"IP Packet Forwarding Filters" on page 55
Value
Node
55:00001B2700F0
All Circuits
Network
12/FFFFFFFF
All Circuits
<Any>
Node
55:00001B2700F0
Network
12/FFFFFFFF
for more information.