Novell NETWARE 6-DOCUMENTATION Manual page 1915

Table 5
IP Packet Forwarding Filters
Configuring IP Packet Forwarding Filtering
When configuring this example, set the parameters as shown in
Parameters for IP Outgoing Routing Information Filter Example
Parameter
Action
Filters:
Route to Network or Host
IP Address of Network Host
Subnet Mask
Destination Type
Destination
IP packet forwarding filters let the router filter packets selectively, according
to their type, source, and destination.
Before you begin, make sure that filtering support is enabled for IP in
NIASCFG. Otherwise, filtering will not work.
To configure IP packet forwarding filtering, complete the following steps:
1
Load FILTCFG, then select the following parameter path:
Select Configure TCP/IP Filters > Packet Forwarding Filters
2
Select Status and toggle the choice to read Enabled or Disabled .
Any configured filters immediately become active (enabled) or inactive
(disabled).
3
Select Action and toggle the choice to permit or deny the packets in the
filter list.
If denied, matching packets are not forwarded by the router. If permitted,
matching packets are forwarded by the router.
4
Select Filters .
This lists the packets that are permitted or denied, according to the Action
parameter setting.
Value
Deny Routes
.
Network
151.1.0.0
255.255.255.0
Interface
FDDI Interface
Table 5 .
55
Setting Up