Figure 3-141 Protocol Vlan System Configuration - SMC Networks 6152PL2 Management Manual

CLI – This example shows the switch configured with Protocol Group 2 which
matches RFC 1042 IP traffic.
Console(config)#protocol-vlan protocol group 2 add frame-type
rfc-1042 protocol-type ip
Console(config)#
Use the Protocol VLAN System Configuration menu to map a Protocol VLAN Group
to a VLAN.
Command Usage
• When creating a protocol-based VLAN, only assign interfaces using this
configuration screen. If you assign interfaces using any of the other VLAN menus
such as the VLAN Static Table (page 3-224) or VLAN Static Membership by Port
menu (page 3-226), these interfaces will admit traffic of any protocol type into the
associated VLAN.
• If the frame is tagged, it will be processed according to the standard rules applied
to tagged frames.
• If the frame is untagged and the protocol type matches, the frame is forwarded to
the appropriate VLAN.
• If the frame is untagged but the protocol type does not match, the frame is
forwarded to the default VLAN for this interface.
Command Attributes
• Protocol Group ID – Protocol Group ID assigned to the Protocol VLAN Group.
(Range: 1-2147483647)
• VLAN ID – VLAN to which matching protocol traffic is forwarded. (Range: 1-4094)
Web – Click VLAN, Protocol VLAN, System Configuration.
CLI – This example shows the switch configured with Protocol Group 2 mapped to
VLAN 2.
Console(config)#protocol-vlan protocol-group 2 vlan 2
Console(config)#

Figure 3-141 Protocol VLAN System Configuration

VLAN Configuration
4-328
4-328
3-245
3