ZyXEL Communications ENTERPRISE NETWORK CENTER Manual page 39

Figure 23 Right-click Menus: Add Device - Step 3
The following table describes the labels in this screen.
Table 13 Right-click Menus: Add Device
LABEL
Add Device - Step 1
Device Type
Device Model
Cancel
Next
Add Device - Step 2
Device Type
Device Model
MAC Address
Device Name
Mapped Room No.
IP Address
Location
Description
Cancel
Previous
Next
Add Device - Step 3
SNMP Version
Port
ENC User's Guide
DESCRIPTION
Select the type of the device you want to add.
Select the exact model name of the device if you can find it. If you cannot find
an appropriate one, select device type Others, click Next and then fill it in the
Device Name in the next screen.
Click this to exit this screen and go back to the previous screen.
Click this to proceed to the next screen.
This field displays the device type you just selected.
This field displays the model name and the associated icon you just selected.
Enter the MAC address of the device.
Enter up to 32 characters for the name of the device. You can use
alphanumeric characters (0-9, a-z, A-Z), underscores (_), hyphens (-) and/or
dots (.).
Enter the number of the room where the device is located.
Enter the IP address of the device.
Type where you locate the device.
Type additional information about the device.
Click this to exit this screen and go back to the previous screen.
Click this to go back to the last screen.
Click this to proceed to the next screen.
Select the version of the SNMP poll messages the ENC sends in order to
communicate with the device.
Enter the port number the ENC uses to transmit and receive SNMP messages
to/from the device.
Chapter 1 Web Configurator
39