ZyXEL Communications ENTERPRISE NETWORK CENTER Manual page 200

Chapter 8 Application
After you configure the event, you can then create an alarm and associate it with the event. An
alarm here defines:
• which port or interface on the port will generate this alarm,
• a variable that you wish to monitor,
• which method to use for collecting data samplings,
• the falling and rising threshold values that determine when to trigger this alarm,
• and the application name that creates this alarm entry.
Figure 148 RMON > Event / Alarm
The following table describes the labels in this screen.
Table 90 RMON > Event / Alarm
LABEL
Event List
Add
Edit
Remove
check box
Type
Last Event
Send
Community
Description
Owner
Alarm List
Add
202
DESCRIPTION
Click this to create a new event.
Select an entry in the table and click this to modify it.
Select an entry in the table and click this to delete it.
Select the check box of an entry and click Edit or Remove to take the action for
the entry respectively. Select or clear the check box at the table heading line to
select or clear all check boxes in this column.
This field displays the alarm type (NONE, LOG, TRAP or LOG & TRAP).
LOG - The device generates a log when an associated alarm occurs.
TRAP - The device sends a trap when an associated alarm occurs.
NONE - The device does not generate any logs or traps when an associated alarm
occurs.
LOG & TRAP - The device generates a log and sends a trap when an associated
alarm occurs.
This field displays the date and time the event was last generated and sent from
the device to the ENC.
This field displays the SNMP Get/Set community setting.
This field displays further information about the event.
This field displays the name of the application that created this event.
Click this to create a new alarm.
ENC User's Guide