ZyXEL Communications ENTERPRISE NETWORK CENTER Manual page 142

Chapter 6 Tool
The following table describes the labels in this screen.
Table 51 Tool > Inventory > Device
LABEL
Name
Device Type
IP Address
Status
Firmware
Device Model
Device Group
Enable Status
Polling
Discovered Date
Support SNMP
Search
View Events
Remove
142
DESCRIPTION
Enter a partial or full name of a device for which to search.
Select the type of the device for the search criteria. The available options are Host,
Switch, Firewall, Wireless AP, Router/Gateway, Wireless Controller, IP PBX, IP
Phone, Peripheral, NWA1300-N Series, Others and All.
Host: such as a computer or a device that does not respond to the ENC through SNMP but
the ENC can ping to it.
Others: these are devices that support SNMP but for which the ENC cannot find a
matching device type in its database or the ENC fails to get the device's type. For
example, a non-ZyXEL switch.
Peripheral: such as a printer or digital photo frame. This type of device must be manually
added to the ENC.
Wireless Controller: such as ZyXEL NXC-8160. At the time of writing, the ENC does not
support the device.
Enter a partial or full IP address for the search criteria. This field does not support
asterisks as wildcards. Leave this field blank to not specify the criteria.
Select the device status (Online, Offline, Un-monitored or All) for the search criteria.
Enter a partial or full firmware version of the device for the search criteria. Leave this field
blank to not specify the criteria.
Select the device model name for the search criteria.
Select a device group (configured in the Tool > Device Group screen) or All device
groups for the search criteria.
Select whether status polling is enabled (true) or not (false) or both (All) for the search
criteria.
Select within the number of hours or days in the past the device was discovered by the
ENC for the search criteria. The options are Last 24 hours, Last 48 hours, Last 5 days,
Last 7 days and Last 30 days. Select All to not specify the criteria. Select Custom to
display additional fields if you want to customize a period for the search criteria. Click the
text box next to Start Date or End Date, a calendar displays as shown next.
Figure 98 Customize a Period
Choose a date (or click Today) and click Done to close the calendar. The ending date
must not be earlier than the starting date.
Select whether the device enables SNMP (Yes or No) or both (All) for the search criteria.
Click this to perform the search.
Select one or multiple table entries and click this to view the events about the devices.
See Section 5.1 on page 123
Select one or multiple table entries and click this to delete them.
for more information.
ENC User's Guide