The Ap Configuration Screen - ZyXEL Communications ENTERPRISE NETWORK CENTER Manual

Table 112 AP Manager > AP Profile > Add/Edit (continued)
LABEL
WEP Key
Authenticati
on Method
Cancel
Ok

8.12.3 The AP Configuration Screen

Use this screen to search and check the basic settings such as IP address, MAC address and AP
profile for wireless APs. To open this screen, click Application > AP Manager > AP
Configuration.
Figure 182 AP Manger > AP Configuration
The following table describes the labels in this screen.
Table 113 AP Manger > AP Configuration
LABEL
Name
Device Model
IP Address
ENC User's Guide
DESCRIPTION
The WEP keys are used to secure your data from eavesdropping by unauthorized
wireless users. Both the wireless AP and wireless clients must use the same WEP
key for data transmission.
If you chose 64 Bit in the Encryption field, then enter any 5 ASCII characters or
10 hexadecimal characters ("0-9", "A-F") for each key.
If you chose 128 Bit in the Encryption field, then enter 13 ASCII characters or 26
hexadecimal characters ("0-9", "A-F") for each key.
You must configure all four keys. Only one key can be activated at any one time.
Select a default key to use for data encryption.
Select Open System, Shared Key or Both.
This field specifies whether the wireless clients have to provide the WEP key to
login to the wireless network. Keep this setting at Both or Open System unless
you want to force a key verification before communication between the wireless
client and the wireless AP occurs. Select Shared Key to force the clients to provide
the WEP key prior to communication.
Click this to discard all changes and close the screen.
Click this to save the settings and close this screen.
DESCRIPTION
Enter the full or partial name of the device you are looking for.
Select the device model name for the search criteria.
Enter an IP address for the search criteria.
Chapter 8 Application
237