Configuring Ip Parameters; Selecting Printer Languages - Ricoh fax3310l Basic Features

7.7 Running Telnet

7.7.2 Configuring IP Parameters

Although the Network Interface Board must have an IP address before a Telnet connection
can be made, you can use the Telnet utility to change the address or the other IP
parameters. The Network Interface Board automatically initiates a soft reset when it
senses the IP address change.
Note: This causes the Telnet connection to be broken. It is advisable to make all other
desired changes before changing the IP address.
To configure IP parameters:
At the main menu, type 1 and press Enter to display the IP Parameters menu.
1.
2. Type 1 again and press Enter.
The IP Address submenu is displayed:
Type the number for the parameter you want to change and press Enter.
3.
The base port number is one less than the actual TCP/IP port number used by the
Note:
printer. For example, to set the port number to 9100, enter 9099.

7.7.3 Selecting Printer Languages

Selection 2 in the main menu lets you designate the emulations (printer interpreter
languages) that the printer supports. This lets the resident
for other emulations so they can be printed. The menu also allows you to enable or disable
banners attached to
The emulation choices are:
• Printer Control Language (PCL)
• PostScript (PS)
• ASCII (simple text)
• Other (any print job not recognized as PCL, PS, or ASCII)
7-14
1. IP Address
2. Subnet Mask
3. Default Gateway
4. Base Port Number 10000
/ handled jobs.
lpd lpr
199.92.187.37
255.255.255.0
199.92.187.254
lpd
/ modify files intended
lpr
TCP/IP Configuration