Ricoh fax3310l Basic Features page 438

5.2 Windows IP Peer-to-Peer Printing
Field or Button
IP Port Base
Printer Names
5-8
The starting port number for the print server. Each print server
is assigned an IP port number. By default, the Network
Interface Board is assigned port number 10001. However, the
network administrator can change this setting. If the print
servers on your network have been configured to use a
different set of port numbers, then you should configure the IP
Peer-to-Peer software accordingly. Note that IP Peer-to-Peer
uses the new port number to communicate with all print
servers.
Note: The IP Port selected here and in the print server should
be one less than the actual port. For example, if port 10001 is
desired, the IP Port on the this screen and on the Network
Interface Board's HTML pages should be defined as 10000.
Lets you select how the printer names are displayed in the
Windows Port List:
• Based on Serial Number — Uses the print server serial
number to identify the printer names. For example, if
SN991354 is the serial number of the unit, SN991354
would be the printer port.
• Based on IP Address — Uses the IP address to identify the
printer port. For example, if the IP address for the unit is
199.99.92.99, the printer port is also 199.99.92.99. (This is
the default.)
• Based on DNS — Uses the Domain Name Server (DNS)
name to identify the printer name.
• Based on Unit Name — Uses the Network Interface Board
Peer-to-Peer name set in the Novell section of the print
server setup. This is the name used to identify the printer.
The default name is the Network Interface Board serial
number (six digits with a three-letter prefix).
Note: If you have both the IP Peer-to-Peer and IPX Peer-to-
Peer Redirector Programs installed, you should not select the
option to display IP Peer-to-Peer units based on Unit Name.
This conflicts with the IPX Peer-to-Peer redirector and may
cause conflicts in the Windows Printer Port List.
Description
Windows Peer-to-Peer Printing