Solving Problems - Ricoh fax3310l Basic Features

Solving Problems

This table lists some common problems and their solutions.
Problem
Printed or sent image contains spots.
Received image is too light.
Message appears blank at the other
end.
You want to cancel a Memory Trans-
mission.
You want to cancel an Immediate
Transmission.
You cannot add any destinations to a
Group, even though the maximum
number of destinations has not been
reached.
Required Action
The Document Feeder (ADF) or scanner is dirty. Clean
them.
Make sure that ink or correction fluid is dry before set-
ting the original.
Reference
See p.112 "Cleaning the Scanner", <Advanced Fea-
tures> .
Request the sender to increase the image density.
When using moist, rough or processed paper, the
printed image may be hard to see. Only use recom-
mended paper.
Reference
See p.127 "Originals", <Advanced Features> .
When D appears on the display, toner is beginning to
run out. Replace the toner cassette soon.
Reference
See p.117 "Replacing the Toner Cassette", <Ad-
vanced Features> .
The original was set upside down. Set it properly.
Reference
See p.23 "Setting Originals".
If the original is being stored, press the { { { { Clear/Stop} } } } key.
Reference
See p.27 "Canceling a Memory Transmission".
If the original is being sent, use "Cancel TX/RX" in the
Job Information menu.
Reference
See p.13 "Canceling Transmission or Reception",
<Advanced Features> .
Press the { { { { Clear/Stop} } } } key.
Reference
See p.31 "Canceling an Immediate Transmission".
69 destinations have been programmed with the num-
ber keys. Program more numbers with Quick Dials or
Speed Dials.
Reference
See p.57 "Groups"
Solving Problems
4
77