Configuring Network Settings
This section describes configuring the settings required to use the machine on a network.
In this manual, "IP address" covers both IPv4 and IPv6 environments. Read the instructions that are
relevant to the environment you are using.
Configuring the IP Address Settings
The procedure for configuring network settings differs depending on whether the IP address is assigned
automatically by the network (DHCP), is specified manually.
• The password for accessing the [Network Settings] menu can be specified in [Admin. Tools Lock].
• If your network environment requires a specific transmission speed that is not automatically
detected, specify the transmission speed in [Set Ethernet Speed] under [Network Settings].
• First configure the IP address setting, then install the driver. For details about installing the driver,
see page 122 "Installing the Driver and Software".
• For details about printing the configuration page, see page 155 "Printing Lists/Reports".
Specifying settings to receive an IPv4 address automatically
• A DHCP server is required on the network for the machine to receive an IPv4 address
automatically.
1.
Press the [User Tools] key.
2.
Press the [ ] or [ ] key to select [Network Settings], and then press the [OK] key.
3.
If you are requested to enter a password, enter the password using the number keys,
and then press the [OK] key.
DJC033
Configuring Network Settings
29