1. Guide to the Machine
Configuring Network Settings
FiO
This section describes configuring the settings required to use the machine on a network.
• Ethernet and wireless LAN settings cannot be enabled at the same time.
Switch the LAN Type
You can select either [Ethernet] or [Wireless LAN].
• You only need to configure this setting for the Type 4 model.
1.
Press the [User Tools] key.
ctt129.pdf (alt="User Tools key
2.
Press the [
select [Network Settings], and then press the [OK] key.
3.
Press the [
select [LAN Type], and then press the [OK] key.
4.
Press the [
select [Ethernet] or [Wireless LAN], and then press the [OK] key.
After a setting is changed, the machine automatically restarts.
Configuring the IP Address Settings Using the Control Panel
The procedure for configuring network settings differs depending on whether IP address information is
assigned automatically by the network (DHCP), or manually.
The IP address can also be configured via Web Image Monitor. For details about configuring the IP
address, see page 161 "Using Web Image Monitor".
30
illustration" title="")
(alt="Down arrow
key"
(alt="Down arrow
key"
(alt="Down arrow
key"
CTT129
title="")] or [
(alt="Up arrow
title="")] or [
(alt="Up arrow
title="")] or [
(alt="Up arrow
opal-p1_mf1_wi-fi_user_guide_gb_00104815_eng.xml
key"
title="")] key to
key"
title="")] key to
key"
title="")] key to
Draft 2013/03/07