Network Monitoring Commands; Show Packet Ports - D-Link DES-3010F Command Line Interface Reference Manual

The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command

show packet ports

show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog
delete syslog host
show syslog host
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the packets analysis for port 7:
DES-30XX Layer 2 Switch CLI Reference Manual
N
ETWORK
Parameters
<portlist>
<portlist>
[cpu | ports {<portlist>}]
{ports <portlist>}
{index <value_list X-Y>}
<index 1-4> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | ipaddress <ipaddr> state [enable | disable]}
{host [all <index 1-4>]} {severity [informational | warning | all] |
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <udp_port_number> | ipaddress <ipaddr> | state
[enable | disable]}
[<index 1-4> | all]
{<index 1-4>}
Used to display statistics about the packets sent and received by the
Switch.
show packet ports <portlist>
This command is used to display statistics about packets sent and
received by ports specified in the port list. The results are separated
into three tables, labeled A, B, and C in the window above. Table A
is relevant to the size of the packets, Table B is relevant to the type
of packets and Table C is relevant to the type of frame associated
with these packets.
<portlist> − Specifies a port or range of ports to be displayed.
None.
M
ONITORING
57
9
C
OMMANDS