To Delete A Member; To Add A Member - D-Link DES-3010F Command Line Interface Reference Manual

config sim_group
Restrictions
Example usage:

To add a member:

DES-3026:4#config sim_group add 2
Command: config sim_group add 2
Please wait for ACK...
SIM Config Success !!!
Success.
DES-3026:4#

To delete a member:

DES-3026:4#config sim_group delete 1
Command: config sim_group delete 1
Please wait for ACK...
Success.
DES-3026:4#
config sim
Purpose
Syntax
Description
Parameters
DES-30XX Layer 2 Switch CLI Reference Manual
delete <member_id 1-32> - Use this parameter to delete a member
switch of a SIM group. The member switch should be defined by it ID
number.
Only administrator-level users can issue this command.
Used to configure role parameters for the SIM protocol on the
Switch.
config sim [[commander {group_name <groupname 64>} |
candidate] | dp_interval <30-90> | hold_time <sec 100-255>]]
This command is used to configure parameters of switches of the
SIM.
commander – Use this parameter to configure the commander
switch for the following parameters:
group_name <groupname 64> - Used to update the name of the
group. Enter an alphanumeric string of up to 64 characters to
rename the SIM group.
dp_interval <30-90> – The user may set the discovery protocol
interval, in seconds that the Switch will send out discovery packets.
Returning information to the commander switch will include
information about other switches connected to it. (Ex. MS, CaS).
The user may set the discovery protocol interval from 30 to 90
seconds.
hold time <sec 100-255> – Using this parameter, the user may set
the time, in seconds, the Switch will hold information sent to it from
other switches, utilizing the discovery interval protocol. The user
161