Broadcast Storm Control Commands; Config Traffic Control - D-Link DES-3010F Command Line Interface Reference Manual

The broadcast storm control commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command

config traffic control

show traffic control
Each command is listed, in detail, in the following sections.
config traffic control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure traffic control and enable broadcast storm control system wide:
DES-3026:4# config traffic control all broadcast enable
Command: config traffic control all broadcast enable
Success.
DES-3026:4#
DES-30XX Layer 2 Switch CLI Reference Manual
B
ROADCAST
Parameters
[<storm_grouplist> | all] {broadcast [enable | disable] | multicast
[enable | disable] | dlf [enable | disable] | threshold <value 64-
1024000>}
{group_list <storm_grouplist>}
Used to configure broadcast / multicast traffic control.
config traffic control [<storm_grouplist> | all] {broadcast
[enable | disable] | multicast [enable | disable] | dlf [enable |
disable] | threshold <value 64-1024000>}
This command is used to configure broadcast storm control.
<storm_grouplist> − Used to specify a broadcast storm control
group. The grouplist corresponds to the port number on the Switch.
all − Specifies all broadcast storm control groups on the Switch.
broadcast [enable | disable] − Enables or disables broadcast storm
control.
multicast [enable | disable] − Enables or disables multicast storm
control.
dlf [enable | disable] − Enables or disables dlf traffic control.
threshold <value 64-1024000> − The upper threshold at which the
specified traffic control is switched on. The value is the amount of
broadcast/multicast/dlf traffic, in Kbps, received by the Switch that
will trigger the storm traffic control measures. The value ranges in
size from 64 to 1024000 Kpps.
Only administrator-level users can issue this command.
S C
TORM ONTROL
80
12
C
OMMANDS