Enable Smtp; To Enable Smtp On The Switch - D-Link DES-3010F Command Line Interface Reference Manual

•
If the initial message sent to a mail recipient is not delivered, it will be placed in the waiting queue until its place in the
queue has been reached, and then another attempt to transmit the message is made.
•
The maximum attempts for delivering mail to recipients is three. Mail message delivery attempts will be tried every five
minutes until the maximum number of attempts is reached. Once reached and the message has not been successfully
delivered, the message will be dropped and not received by the mail recipient.
•
If the Switch shuts down or reboots, mail messages in the waiting queue will be lost.
The SMTP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command

enable smtp

disable smtp
config smtp
show smtp
smtp send_testmsg
Each command is listed, in detail, in the following sections.
enable smtp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To enable SMTP on the Switch.

DES-30XX Layer 2 Switch CLI Reference Manual
Parameters
{server <ipaddr> | server_port <tcp_port_number 1-65535> |
self_mail_addr <mail_addr 64> | [add mail_receiver <mail_addr
64> | delete mail_receiver <index 1-8>]}
Used to enable the Switch as a SMTP client.
enable smtp
This command, in conjunction with the disable smtp command
will enable and disable the Switch as a SMTP client without
changing configurations.
None.
Only administrator-level users can issue this command.
DES-3026:4#enable smtp
Command: enable smtp
Success.
DES-3026:4#
48