config cpu access_profile
ip − Specifies that the Switch will look into the IP fields in each packet.
•
•
•
•
•
•
•
•
•
•
DES-30XX Layer 2 Switch CLI Reference Manual
vlan <vlan_name 32> − Specifies that the access profile will apply to
only this VLAN.
source_ip <ipaddr> − Specifies that the access profile will apply to
only packets with this source IP address.
destination_ip <ipaddr> − Specifies that the access profile will apply to
only packets with this destination IP address.
dscp <value 0-63> − Specifies that the access profile will apply only to
packets that have this value in their Type-of-Service (DiffServ code
point, DSCP) field in their IP packet header
icmp − Specifies that the Switch will examine the Internet Control
Message Protocol (ICMP) field within each packet.
type <value 0-255> − Specifies that the access profile will
•
apply to this ICMP type value.
code <value 0-255> − Specifies that the access profile will
•
apply to this ICMP code.
igmp − Specifies that the Switch will examine the Internet Group
Management Protocol (IGMP) field within each packet.
type <value 0-255> − Specifies that the access profile will
•
apply to packets that have this IGMP type value.
tcp − Specifies that the Switch will examine the Transmission Control
Protocol (TCP) field within each packet.
src_port <value 0-65535> − Specifies that the access profile
•
will apply only to packets that have this TCP source port in
their TCP header.
dst_port <value 0-65535> − Specifies that the access profile
•
will apply only to packets that have this TCP destination port
in their TCP header.
protocol_id <value 0-255> − Specifies that the switch will examine the
Protocol field in each packet and if this field contains the value
entered here, apply the following rules.
udp − Specifies that the Switch will examine the Transmission Control
Protocol (TCP) field within each packet.
src_port <value 0-65535> − Specifies that the access profile
•
will apply only to packets that have this UDP source port in
their header.
dst_port <value 0-65535> − Specifies that the access profile
•
will apply only to packets that have this UDP destination port
in their header.
protocol_id <value 0-255> − Specifies that the Switch will examine the
protocol field in each packet and if this field contains the value entered
here, apply the following rules.
user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule
•
applies to the IP protocol ID and the mask options behind the IP
header.
119