Traffic Segmentation Commands; Config Traffic_Segmentation - D-Link DES-3010F Command Line Interface Reference Manual

Traffic segmentation allows you to further sub-divide VLANs into smaller groups of ports that will help to reduce traffic on the
VLAN. The VLAN rules take precedence, and then the traffic segmentation rules are applied. The traffic segmentation
commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command

config traffic_segmentation

show traffic_segmentation
Each command is listed, in detail, in the following sections.
config traffic_segmentation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
DES-3026:4#config traffic_segmentation 1-10 forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
DES-3026:4#
DES-30XX Layer 2 Switch CLI Reference Manual
T
RAFFIC
Parameters
[<portlist>] forward_list [null | <portlist>]
{<portlist>}
Used to configure traffic segmentation on the Switch.
config traffic_segmentation [<portlist>] forward_list [null |
<portlist>]
The config traffic_segmentation command is used to configure
traffic segmentation on the Switch.
<portlist> − Specifies a port or range of ports to be configured for
traffic segmentation.
forward_list − Specifies a port or range of ports that will receive
forwarded frames from the ports specified in the portlist, above.
null − No ports are specified
•
<portlist> − Specifies a range of ports for the forwarding list.
•
This list must be on the same switch previously specified
for traffic segmentation (i.e. following the <portlist>
specified above for config traffic_segmentation).
Only administrator-level users can issue this command.
S
EGMENTATION
91
14
C
OMMANDS