Config Arp_Aging Time; To Configure Arp Aging Time - D-Link DES-3010F Command Line Interface Reference Manual

DES-3026:4#show arpentry
Command: show arpentry
ARP Aging Time : 20
Interface
-------------
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
System
Total Entries = 20
DES-3026:4#

config arp_aging time

Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:

To configure ARP aging time:

DES-3026:4#config arp_aging time 30
Command: config arp_aging time 30
Success.
DES-3026:4#
DES-30XX Layer 2 Switch CLI Reference Manual
IP Address MAC Address
--------------- -----------------
10.0.0.0 FF-FF-FF-FF-FF-FF
10.1.1.169 00-50-BA-70-E4-4E
10.1.1.254 00-01-30-FA-5F-00
10.9.68.1 00-A0-C9-A4-22-5B
10.9.68.4 00-80-C8-2E-C7-45
10.10.27.51 00-80-C8-48-DF-AB
10.11.22.145 00-80-C8-93-05-6B
10.11.94.10 00-10-83-F9-37-6E
10.14.82.24 00-50-BA-90-37-10
10.15.1.60 00-80-C8-17-42-55
10.17.42.153 00-80-C8-4D-4E-0A
10.19.72.100 00-50-BA-38-7D-5E
10.21.32.203 00-80-C8-40-C1-06
10.40.44.60 00-50-BA-6B-2A-1E
10.42.73.221 00-01-02-03-04-00
10.44.67.1 00-50-BA-DA-02-51
10.47.65.25 00-50-BA-DA-03-2B
10.50.8.7 00-E0-18-45-C7-28
10.90.90.90 00-01-02-03-04-00
10.255.255.255 FF-FF-FF-FF-FF-FF
Used to configure the age-out timer for ARP table entries on the
Switch.
config arp_aging time <value 0-65535>
This command sets the maximum amount of time, in minutes, that
an ARP entry can remain in the Switch's ARP table, without being
accessed, before it is dropped from the table.
time <value 0-65535> − The ARP age-out time, in minutes. The
value may be set in the range of 0-65535 minutes with a default
setting of 20 minutes.
Only administrator-level users can issue this command.
153
Type
---------------
Local/Broadcast
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Local
Local/Broadcast