Table of Contents
Advertisement
7-5 Uploading, Downloading, and Comparing Component Parameters
7-5-3
Downloading the Component Parameters to the Components
Two methods can be used download component parameters from a computer to a
component on the network.
• Downloading using the Parameter Edit Dialog Box
• Downloading using the Network Configuration Transfer
Downloading Using the Parameter Edit Dialog Box
Use the following procedure to download parameters using the Parameter Edit Dialog
Box.
1. Connect the CX-Integrator online.
2. Select the component from which you want to download parameters from the
3. Right-click and select Parameter - Edit from the menu.
4. Click the Transfer [PC to Unit] Button located on the General Tab Page for the
Note: The settings in the Unit will be returned to their default values if the Default Setting
5. Click the Yes Button to start the parameter download.
Note: A confirmation dialog box will be displayed if the enable/disable settings for the
7-5-3 Downloading the Component Parameters to the Components
CompoNet Network.
Master Unit or Slave Unit.
Button is clicked. Nothing will change in the dialog box, so do not click this button
carelessly.
If the Master Unit is selected, a confirmation dialog box will be displayed. (See
note.)
Registration Table and Software Setting Mode are not the same on the computer and
in the actual components. Refer to 7-6 Editing Master Unit Parameters and to the
manual for the Master Unit for information on the Registration Table and Software
Setting Mode.
7-15
Advertisement
Table of Contents
