Table of Contents
Advertisement
Note
The serial port's CPU SIOU value (unit number) is allocated automatically, so it
cannot be changed. The following FINS unit addresses (decimal) are allocated.
Serial Communications Unit
Serial Communications Board
CPU Unit
A Unit and the Unit's serial port cannot be registered in the local network table at the
same time.
Setting the Relay Network Table
Set the relay network table for PLC1.
1. Click the Table View Tab at the bottom of the PLC Routing Table Window to
switch to the Table View format.
2. Input the destination (remote) network address, relay network address, and relay
node address and click the OK Button.
3-2 Setting the Routing Tables
3-2-2 Creating the FINS Local Routing Tables
Serial port 1
Serial port 2
Serial port 1
Serial port 2
Peripheral port
RS-232C port
80 hex + 04 hex ×
unit number
81 hex + 04 hex ×
unit number
E4 hex (228 decimal)
E5 hex (229 decimal)
FD hex (253 decimal)
FC hex (252 decimal)
3-17
Advertisement
Table of Contents
