Table of Contents
Advertisement
7-4
Component Monitor
The Component Monitor function monitors the CompoNet Network components and
communications status. If an error occurs, it quickly identifies the cause and provides
the network status.
7-4-1
Starting Monitoring
Use the following procedure to monitor components (Master Unit and Slave Units).
Note: The information that can be monitored depends on
1. With the CX-Integrator online, transfer the network configuration to the
2. Right-click the component to monitor in the Network Configuration Window and
3. To quit the monitor function, click the Close Button.
Note
The contents of the Monitor Window depends on the component. For information on the
contents that can be monitored, refer to the Unit manual.
CX-Integrator
Monitoring Master Unit
Monitoring Slave Units
the component.
computer. Alternatively, the network configuration can be read from a
CX-Integrator project file before going online.
select Monitor.
Alternatively, select the component to monitor and select Monitor from the
Component Menu.
The Component Monitor Window will be displayed.
Information about the Network Status, Slave Status, Unit Status, Error History,
and Error Counter will be displayed in the Monitor Window on the Master Unit.
7-4 Component Monitor
Monitoring Slave participation status and error history
CompoNet Master Unit
CS/CJ-series PLC
CompoNet Network
Word Slaves
7-4-1 Starting Monitoring
Bit Slaves
7-7
Advertisement
Table of Contents
